• Cisco 300-101 Route, 300-115 Switch and 300-075 CIPTV2 exam dumps have been updated on Apr.13, 2018.
  • New feedback from our customer, passed 200-150 DCICN exam with your dumps, thanks.
  • New Cisco 500-301 CCS, 700-265 and 500-551 exam dumps are available.

Tag Archives: 300-115 Switch exam dumps

03 7月

Cisco 300-115 SWITCH Exam Dumps Updated

Share 300-115 SWITCH exam news with you, Cisco certification 300-115 SWITCH exam dumps have been updated, which contain 674 questions and answers. Our updated Cisco 300-115 SWITCH exam dumps can make sure you pass the test in the first attempt.

Share some Cisco 300-115 SWITCH exam dumps questions below.

Which three functions does Dynamic ARP Inspection perform with invalid IP-to MAC address bindings? (Choose there.)
A. accepts
B. deletes
C. discards
D. bypasses
E. intercepts
F. logs
Answer: CEF

Which two statements about 802. 1q are true? (Choose two )
A. It encapsulates the original Ethernet frame and adds a VLAN identifier.
B. It increases the maximum size an Ethernet frame to 1094 bytes.
C. It is a Cisco proprietary protocol.
D. When It is enabled, it forces a recalculation of the frame check sequence field.
E. It supports 8-byte VLAN identifiers.
F. It adds a 32-bit field to the Ethernet frame between the source MAC address and length fields.
Answer: BE

A physical switch port is part of an EtherChannel group. What happenes while the same port configured as a SPAN destination?
A. The port forwards traffic in the EtherChannel group and acts as a SPAN source simultaneously.
B. The port is removed from the EtherChannel group.
C. The port is put in the errdisabled state and can only be reenabled manually.
D. The operation is not allowed as an EtherChannel member cannot be a SPAN source port.
Answer: D

Which two statements about CDP are true? (Choose two.)
A. CDP uses a TLV to advertise the native VLAN
B. CDP is not supported with SNMP
C. CDP is supported on Frame Relay sub interfaces.
D. CDP runs on OSI layer 2
E. CDP runs on OSI layer 1
Answer: AC

13 4月

Updated Version of Cisco 300-115 Switch Free Online Test

300-115 Switch exam dumps have been updated. We provide 10 new questions of 300-115 Switch updated dumps. Answer one question correctly, you can get 10 points. The content of these questions are the latest exam content. Please feel free to test your skill level.

If you have some opinions or suggestions about our online test, please leave your message, we will improve it step by step.

Now, begin to test:

1. During routine maintenance, G1/0/1 on DSW1 was shutdown. All other interface were up. DSW2 became the active HSRP device for Vlan101 as desired. However, after G1/0/1 on DSW1 was reactivated. DSW1 did not become the active HSRP device as desired.What need to be done to make the group for Vlan101 function properly?


2. All interfaces are active. DSW2 has not become the active device for the VLAN 103 HSRP group.As related to the VLAN 103 HSRP group, what can be done to make the group function properly?


3. If G1/0/1 on DSW1 is shutdown, what will be the current priority value of the Vlan105′s group on DSW1?


4. What is the priority value of the Vlan105′s group on DSW2?


5. During routine maintenance, it became necessary to shutdown G1/0/1 on DSW1 and DSW2. All other interface were up. During this time, DSW1 became the active device for Vlan104′s HSRP group.As related to Vlan104′s HSRP group, what can be done to make the group function properly?


6. If GigabitEthemet1/0/1 on DSW2 is shutdown, what will be the resulting priority value of the VLAN 105 HSRP group on router DSW2?


7. HSRP case 2

Your customer has asked you to come in and verify the operation of routers R1 and R2 which are configured to use HSRP. They have questions about how these two devices will perform in the event of a device failure.

What percentage of the outgoing traffic from the subnet is being forwarded through R1?


8. Refer to the exhibit.

If router R1 interface Etherne0/0 goes down and recovers, which of the statement regarding HSRP priority is true?


9. What issue is causing Router R1 and R2 to both be displayed as the HSRP active router for group 2?


10. What is the virtual mac-address of HSRP group 1?


Question 1 of 10

Recent Posts


300-101 ROUTE and/or Remove an End-Device and/or Remove an Infrastructure Device and/or Remove Cables (network and/or power) Cisco 642-997 DCUFI exam Cisco 642-999 DCUCI exam Configure Cisco Unity Connection Configure Cisco Unity Express using the GUI Describe and implement centralized call processing redundancy Describe Data Center Structure and Modularity Describe the Design Methodology Describe the Technologies used within the Data Center Describe WLAN Fundamentals Design and Deploy WLAN Infrastructure for Mobility Design Network Management Considerations into a Data Center Design the Access Layer of a Data Center General Networking Knowledge given a Network Design and a set of Requirements High Availability Routing Features Identify Cisco Equipment and Related Hardware Implement high availability features on Cisco Unified Fabric products in a Cisco Data Center Architecture Implement Multicast over Wireless Implement QoS for Wireless Applications Implement VoWLAN Infrastructure Security Infrastructure Services Install Integrate Client Device Security IP Services LAN Switching Technologies Layer 2 Technologies Layer 3 Technologies Maintain Appropriate End-Devices and Industrial Network Infrastructure Devices Manage the Unified Fabric in a Cisco Data Center Architecture Monitoring and Reporting Tools Network Principles Replace Service-Related Knowledge Threat Defense Threat Defense Architectures Troubleshoot Call Setup Issues Troubleshooting Troubleshoot Registration Issues VPN Technologies WAN Technologies


Powered by CCNP Exams Test Base