300-075 CIPTV2 Online Test-Implementing Cisco IP Telephony & Video, Part 2 v1.0

Currently, our 300-075 CIPTV2 online test only provide 10 questions. Answer one question correctly, you can get 10 points. The content of these questions are the latest exam content. Please feel free to test your skill level.

If you have some opinions or suggestions about our online test, please leave your message, we will improve it step by step.

Now, begin to test:

Which parameter should be set to prevent H.323 endpoints from registering to Cisco TelePresence Video Communication Server automatically?

On the VCS, navigate to Configuration, Protocols, H.323, and set Auto Discover to off.

On the VCS, navigate to Configuration, Protocols, H.323, and set Auto Registration to off.

On the VCS, navigate to Configuration, Registration, Allow List, and set Auto Registration to off.

On the VCS, navigate to Configuration, Registration, Configuration, and set Auto Registration to off.

Which type of search message appears in the Cisco TelePresence Video Communication Server search history page when it receives a H.323 call from a RAS-enabled endpoint that originates from an external zone?

ARQ

SETUP

LRQ

INVITE

OPTIONS

You want to avoid unnecessary interworking in Cisco TelePresence Video Communication Server, such as where a call between two H.323 endpoints is made over SIP, or vice versa. Which setting is recommended?

H.323 – SIP interworking mode. Reject

H.323 – SIP interworking mode. On

H.323 – SIP interworking mode. Registered only

H.323 – SIP interworking mode. Off

H.323 – SIP interworking mode. Variable

Which three statements about configuring an encrypted trunk between Cisco TelePresence Video Communication Server and Cisco Unified Communications Manager are true? (Choose three.)

The root CA of the VCS server certificate must be loaded in Cisco Unified Communications Manager.

A SIP trunk security profile must be configured with Incoming Transport Type set to TCP+UDP.

The Cisco Unified Communications Manager trunk configuration must have the destination port set to 5061.

A SIP trunk security profile must be configured with Device Security Mode set to TLS.

A SIP trunk security profile must be configured with the X.509 Subject Name from the VCS certificate.

The Cisco Unified Communications Manager zone configured in VCS must have SIP authentication trust mode set to On.

The Cisco Unified Communications Manager zone configured in VCS must have TLS verify mode set to Off.

Which two actions ensure that the call load from Cisco TelePresence Video Communication Server to a Cisco Unified Communications Manager cluster is shared across Unified CM nodes? (Choose two.)

Create a neighbor zone in VCS with the Unified CM nodes listed as location peer addresses.

Create a single traversal client zone in VCS with the Unified CM nodes listed as location peer addresses.

Create one neighbor zone in VCS for each Unified CM node.

Create a VCS DNS zone and configure one DNS SRV record per Unified CM node.

In VCS set Unified Communications mode to Mobile and remote access and configure each Unified CM node.

Which two options are configuration steps on Cisco Unified Communications Manager that are used when integrating with VCS Expressway servers? (Choose two.)

allowing numeric dialing from Cisco phones to Expressway

configuring a device pool with video feature enabled

allowing dialing to Expressway domain from Cisco phones

creating an application user on Cisco Unified Communications Manager with assigned privileges

adding the Expressway servers to the Application Servers list

Which two statements regarding IPv4 Static NAT address 209.165.200.230 has been configured on a VCS Expressway are true? (Choose two.)

The Advanced Networking or Dual Network Interfaces option key has been installed.

VCS rewrites the Layer 3 source address of outbound SIP and H.323 packets to 209.165.200.230.

VCS applies 209.165.200.230 to outbound SIP and H.323 payload messages.

With static NAT enabled on the LAN2 interface, VCS applies 209.165.200.230 to outbound H.323 and SIP payload traffic exiting the LAN1 interface.

Which configuration does Cisco recommend for the peer address on the Expressway-C secure traversal zone when the Expressway-E has one NIC enabled?

Expressway-E internal IP address

Expressway-E external IP address

Expressway-E internal FQDN

Expressway-E external FQDN

If delegated credentials checking has been enabled and remote workers can register to the VCS Expressway, which statement is true?

H.323 message credential checks are delegated.

SIP registration proxy mode is set to On in the VCS Expressway.

A secure neighbor zone has been configured between the VCS Expressway and the VCS Control.

SIP registration proxy mode is set to Off in the VCS Expressway.

Which two options should be used to create a secure traversal zone between the Expressway-C and Expressway-E? (Choose two.)

Expressway-C and Expressway-E must trust each other’s server certificate.

One Cisco Unified Communications traversal zone for H.323 and SIP connections.

A separate pair of traversal zones must be configured if an H.323 connection is required and Interworking is disabled.

Enable username and password authentication verification on Expressway-E.

Create a set of username and password on each of the Expressway-C and Expressway-E to authenticate the neighboring peer.

Question 1 of 10

CCNP Exams Test Base

New CCNP Exams from January 30, 2015

Note:

Tag Archives: 300-075 CIPTV2 online test

300-075 CIPTV2 Online Test-Implementing Cisco IP Telephony & Video, Part 2 v1.0

Recent Posts

Tags

Links